Posted by: RussBaker - Ex Member Posted on: 09/13/06 at 02:46:38
The special tool, yeah right, that would be them laying on your deck to reach there arm in with the long ratchet to get it off or on. Been there done that on many occasions. Russ
Posted by: larrys - Ex Member Posted on: 09/13/06 at 02:32:38
AHA! Fell for the old "There is a special tool "ploy huh? I believe you can also use a long rathet extension and let it lock up against the cap or hull from underneath as you turn the screw from the top...it is a wrestling match depending on the room and access. Now I hav'nt done it for awhile but that is what we did with my Gambler.
p.s. make sure they do not stress fracture the mounts on the fibreglass cap.
Posted by: y2says - Ex Member Posted on: 09/13/06 at 01:59:49
I can't reach the nuts that are holding the screws. I called Anglers marine and they told me there is a special tool that's required. So, I'm just going to have them do it. Kinda sucks to spend money on something you should be able to do yourself.
Posted by: basspro - Ex Member Posted on: 09/11/06 at 18:22:31
Y2,
That depends on which trolling motor you have. Now if it is a MG there will be 4-Jack nuts that the screws thread into and a nylon insert lock nut attached at the bottom of the thread. You have to unscrew the front panel to beable to reach them. Most of the screws are phillips drive so you will need a phillips drive screw driver to loosen them while holding a wrench below on the nuts. Or vice a versa whichever is easier. The nuts are normally 1/4-20 thread and the wrench size you will need for the nut is 7/16.
Hope this helps, Russ
Posted by: y2says - Ex Member Posted on: 09/11/06 at 17:54:23
I purchased a new trolling motor and my brother and I was trying to take the old one out yesterday. We didn't get far because we weren't able to reach the nut that's deep inside the hull. The screws that we cant get out are the ones that are right at the front of the bow. What special tools do we need to reach them?